KFC doors are essentially aluminum alloy doors. Most fast food restaurants such as KFC and McDonald's in the commercial area are Deji doors. Compared with traditional glass doors, steel doors, and rolling doors,KFC doors have better lighting.
The most important thing is that KFC doors are more practical. The practicality of KFC doors is not only affected by its own quality, but also has more to do with installation.
What are the steps to install the KFC door? What are the things to pay attention to during the installation process?
Step 1: clean the door hole, remove the excess part, and ensure that both sides of the door hole are on the vertical line;
Step 2: Install the top shaft part on the door frame;
Step 3: Combine the three profiles of the door frame with screws or rivets;
Step 4: Install the earth axis. make a square pit with a length of 170mm and a width of 120mm and a depth of 55mm on the ground. When fixing the earth axis, use a wire hammer to fix the ground shaft from the center of the top shaft perpendicular to the center of the ground shaft bearing, and then proceed to the next step after the cement is dry.
Step 5: Install the upper shafts and lower shafts of the KFC door;
Step 6: Two points to pay attention to before installing KFC door;
1. Loosen the anti-theft locking screw on the door leaf 9;
2. Before installing the door leaf, apply lubricating grease on the ground shaft to make the door leaf open and close freely and increase the service life.
Step 7: Install another door leaf according to the previous step;
Step 8:
1. The method of adjusting the position of the door leaf: Loosen the cover plate to adjust the screw of the ground shaft with a wrench;
2. Debug the up and down method of the door leaf: The specific method is to debug the hexalobe screw on the lower shaft clockwise
Step 9 : anti-theft card bit screw;
Step 10: Install the door closer. For the installation method, please refer to the supporting installation manual. Debug the o
